Structural Welder Relocation assistance available if moving from out of the area up to 4500

POSITION SUMMARY

• Weld structural steel assemblies including beams columns frames plates stiffeners clips connections and other fabricated components.
• Perform fillet groove and other required welds using the welding processes and positions applicable to assigned work.
• Read and interpret shop drawings weld symbols dimensions and connection details before welding.
• Verify that fitted assemblies joint preparation weld size and component placement appear correct before beginning work.
• Follow applicable WPS requirements including process consumable technique and other specified variables.
• Use proper welding sequence and heat control to reduce distortion pulling and movement of structural assemblies.
• Clean weld areas and remove slag spatter or other material as required between passes and after welding.
• Recognize visible weld discontinuities poor fit-up drawing discrepancies or other problems and address or report them promptly.
• Perform minor preparation grinding gouging or weld repair when authorized and required.
• Maintain welding equipment leads guns tools and work areas in serviceable condition.
• Meet reasonable production expectations without sacrificing weld quality or safety.

• Previous structural steel welding experience preferred.
• Ability to pass the applicable M J & H Fabrication structural weld test(s).
• Ability to read structural shop drawings and understand common weld symbols.
• Working knowledge of structural welding practices joint preparation weld sizes and common fabrication terminology.
• Experience with the welding processes used in structural fabrication is preferred.
• Ability to use tape measures squares gauges and common shop measuring tools.

• Consistent welding technique and ability to maintain required weld size and profile.
• Ability to identify obvious fit-up alignment or drawing problems before welding.
• Good mechanical aptitude measurement skills and attention to detail.
• Ability to work from drawings and written instructions with limited supervision once assigned.
• Ability to coordinate effectively with fitters material handlers supervision and Quality personnel.

• Regularly stand bend stoop kneel reach climb and work around large structural assemblies.
• Lift and handle welding equipment tools leads and fabrication materials within safe working limits.
• Work around welding arc sparks grinding heat noise fumes overhead lifting and moving shop equipment.
• Must be able to wear required PPE and safely work in a structural fabrication environment.

• Follow company safety requirements PPE rules hot-work procedures and safe material-handling practices.
• Perform work in accordance with drawings weld symbols WPS requirements and job specifications.
• Do not weld assemblies that are visibly incorrect or questionable without obtaining clarification.
• Protect completed work from unnecessary damage and report defects drawing conflicts or material concerns.
• Maintain a clean and organized work area to reduce hazards and improve fabrication efficiency.

• Pay is dependent on experience skills and qualifications. Insurance benefits are available after successful completion of the probationary period.