CMM Programmer

Location: Erie PA 16501

Class: A

Department/Division: Modern Machining Division

Reports To:Machine Shop Supervisor & Quality Department

Classification: Hourly Non-Exempt (paid overtime)

General

Responsible for inspecting in process and finished parts to ensure that customer requirements are met.

Minimum Qualifications (Knowledge Skills Abilities)

• High school diploma or equivalent.
• Minimum three years experience performing dimensional inspections.
• Minimum two years CMM programming experience on prismatic machined component parts. PC-DMIS software experience preferred.
• Proficient performance of Class B Inspector essential duties.
• Proficient in current computer software.
• Familiarity with Automotive standards

Essential Duties

1. Interpret drawings control plans process instructions and work instructions to determine sample quantities and features to be inspected for lots of parts.
2. Program the CMM in support of new job launches and ongoing production and train others as needed to do so.
3. Use micrometers calipers visual inspection and other gages as required to complete planned inspections.
4. Identify and report conditions that do not meet requirements and approve acceptable parts for shipment or further processing.
5. Transfer rejected parts to staging area and log data into the ERP system.
6. Verify implementation of appropriate corrective action for quality issues.
7. Maintain clean work areas and orderly storage of fixtures gages and special inspection equipment.
8. Wear personal protective equipment and follow safety instructions as required.
9. Perform other duties as assigned.
10. Must have experience.

Physical Requirements

• Must be able to lift parts and other items from floor to waist on a frequent basis while protecting lifted items from damage. Parts weigh up to 50 lbs. occasionally 35 lbs. frequently.
• Must be able to stand for several consecutive hours without rest with frequent bending and reaching.
• Must be able to tolerate a hot work environment seasonally when summer outdoor temperatures combine with residual heat from machines.
• Must be able to walk within and between areas frequently and climb stairs occasionally.

Mental Requirements

• Must be able to understand and carry out written and verbal instructions.
• Must be able to comprehend and comply with detailed gage calibration work instructions and practices.
• Must be able to retain instructions sufficient to perform complex tasks successfully and with very minimal supervision.
• Must be able to read and understand drawings and precision measuring instruments.
• Must be able to comprehend and comply with requirements of the Quality Systems Manual as instructed.

Required Experience:

IC