Fabrication Technician
Share
Job Location:
Horsham, PA - USA
Monthly Salary:
Not Disclosed
Posted on:
30+ days ago
Vacancies:
1 Vacancy
Job Summary
Description:
What you will do
Performs assigned system commissioning using Johnson Controls configuration and commissioning tools. Troubleshoots and resolves basic HVAC mechanical electrical and controls problems. Responds to basic warranty calls.
How you will do it
Loads system-level controller software.
Performs basic commissioning and system diagnostics from system-level controllers to end devices (i.e. sensors actuators etc) and completes all required commissioning documentation.
Keeps management and JCI contractor or customer informed of job progress and issues.
Calibrates systems requiring basic electronic test equipment.
Completes administrative tasks including but not limited to time sheets expense reports and on-site documentation.
Documents changes and provides information for as-built documentation.
Communicates with the JCI contractor or customer upon arrival and before leaving the work site.
Follows all safety standards and attends required safety training. High degree of regard to employee and subcontractor safety.
What we look for
Required
Demonstrated technical aptitude.
Able to use hand and power tools (i.e. drills saws etc.).
Basic computer skills required.
Attention to detail.
Good communication and listening skills.
Depending on location the mounting and termination of low voltage devices may have special licensing requirements.
Performs assigned system commissioning using Johnson Controls configuration and commissioning tools. Troubleshoots and resolves basic HVAC mechanical electrical and controls problems. Responds to basic warranty calls.
How you will do it
Loads system-level controller software.
Performs basic commissioning and system diagnostics from system-level controllers to end devices (i.e. sensors actuators etc) and completes all required commissioning documentation.
Keeps management and JCI contractor or customer informed of job progress and issues.
Calibrates systems requiring basic electronic test equipment.
Completes administrative tasks including but not limited to time sheets expense reports and on-site documentation.
Documents changes and provides information for as-built documentation.
Communicates with the JCI contractor or customer upon arrival and before leaving the work site.
Follows all safety standards and attends required safety training. High degree of regard to employee and subcontractor safety.
What we look for
Required
Demonstrated technical aptitude.
Able to use hand and power tools (i.e. drills saws etc.).
Basic computer skills required.
Attention to detail.
Good communication and listening skills.
Depending on location the mounting and termination of low voltage devices may have special licensing requirements.
| Dimensions Punch Clock Entry |
Additional Details
- What is the maximum Bill Rate within the Market Rate Analysis you will accept for this position : 36.99
- Job Posting Job Category : Light Industrial
- Assignment Start Time : 7:30am
- Assignment End Time : 4:00pm
- Dimensions Punch Clock Entry : No
- Is driving required for the assignment : No
- Is personal vehicle mileage reimbursable : (No Value)
- Is this a government funded project : No
- Will this position be remote : Not Remote - report to worksite/office
- Worker Pay Type for Distribution : Recruited
- Payrolled Candidate Information (if applicable) : (No Value)
Key Skills
- Fashion Retail
- Invoicing
- IT Hardware & Networking
- C#
- AC Maintenance
- Concrete Pump
