Controls Technician II
Controls Technician II
Employer Active
Job Alert
You will be updated with latest job alerts via email
Share
Job Alert
You will be updated with latest job alerts via email
Not Disclosed
Salary Not Disclosed
1 Vacancy
Job Description
Responsibilities
- Service of existing building control systems.
- Startupof complete building control systems.
- Install building control components(controllers panels conduit sensors etc.
- Low voltage control panel building.
- Work closely with our installation subcontractors and coordinate work with them to ensure projects are completed on time as per code standards and contract requirements.
- Perform a pointtopoint checkout per standard procedures.
- Perform software/hardware calibration required for proper equipment and system operation.
- Perform low voltage cable installation/termination for small projects if needed.
- Take on project commissioning activities to include daily meetings and documenting results.
Qualifications
- Ability to own a task from beginning to end. Effectively communicating progress and/or issues about assigned task.
- Can work both independently and as a part of a team.
- Must be able to multitask it is very probable you will be assigned multiple tasks over multiple customers at any given time.
- Basic proficiency in Microsoft suite(Word Outlook Visio Excel PowerPoint)
- Can read schematics (network topologies electrical onelines device wiring drawings control drawings etc...
- Familiarity with CAD construction drawings
- Strong understanding of open protocols (For Example... BACnet IP/BACnet MSTP/Modbus TCP/Modbus RTU)
- Knowledge of terminating wire to terminal blocks to include RS232RS485 and CAT 5/6
- Troubleshooting skills the ability to understand a problem and work toward reasonable solutions
- Maintain proper understandings of code requirements for indoor and outdoor electrical infrastructure and knowledge of handling higher voltageV) for controls purposes
- Has had experience with BMS software Tridium is preferred and understands wire sheet programming and logic.
- Basic networking ability to manipulate pc settings to access set up and commission devices on a network.
- Ability to visit job construction hard hat areas and climb stairs climb ladders maneuver in and around pipework and air ducts and work safely near exposed line voltage and low voltage wiring and terminations.
- Possess valid state motor vehicle license and possess safe driving record as required by companys insurance carrier.
- Outofstate travel will be required (estimated to be up to 75
- Understanding of Mechanical and Electrical equipment in a typical Data Center application
Required Experience:
IC
Employment Type
Full-Time
