TESTING SUPERVISOR ELECTRICAL R098

JOB DESCRIPTION Testing Supervisor - Electrical Qualification • Diploma in Electrical Engineering is preferred. • 5–7 years’ experience in component testing of electrical equipment. • Gulf experience is required. • Oil & Gas industry experience is preferred. Scope of Work • Execute testing and commissioning of electrical equipment. • Validate operational readiness of transformers switchgear UPS systems HVAC MDB LV/MV/HV cable systems lighting transformers VSD step-up transformers PMS/DCS control systems subsea splitter junction boxes and cathodic protection systems. Responsibilities • Test Equipment Handling: Shall be capable of using the latest sophisticated test equipment and executing planned test activities. • Transformer Tests: ratio vector group verification insulation resistance (IR) winding resistance. • Switchgear Testing: CT/VT testing secondary injection numerical relay testing using interface software primary injection vacuum bottle testing circuit breaker timing contact resistance and high-voltage withstand tests. • MCCB Testing: Perform mechanical and electrical function checks contact resistance trip unit verification and primary injection testing of MCCBs. • HV Cable Testing: Resistance measurement IR VLF withstand test and Tan Delta diagnostic test. • Relay/Control panel testing (primary & secondary injection). • Battery Testing: Perform battery discharge tests using load banks such as Torkel ensuring compliance with capacity and endurance requirements. • Lighting/Lux Testing: Carry out lux level measurements to verify compliance with project lighting standards and safety requirements. • Vendor Schematic Review: Read vendor schematic drawings perform scheme verification and propose modifications in RLMU. • SAT Procedures: Review and prepare Site Acceptance Test procedures; execute SAT with vendors and clients. • Daily Test Activities: Prepare and maintain relevant check sheets; ensure test equipment readiness; record results and deviations; collect SAT documentation and witness signatures. • Report Extraction: Extract test reports from instruments (OMICRON Test Universe/PTM Megger VLF sets Torkel load banks) and archive them for audit readiness. • Document test results and prepare compliance reports. • Coordinate with client representatives vendors QC and planning teams to ensure accurate execution and reporting. Competencies • Strong knowledge of electrical testing methodologies and component testing practices. • Experience in testing of electrical components is a must. • Sound knowledge of sophisticated test equipment such as OMICRON and Megger is mandatory. • Hands-on experience with Omicron Test Universe software PTM usage CPC-100 CP-TD CT Analyzer CMC-256/356 battery load banks such as Torkel lux level testing and MCCB testing is required. • Ability to read vendor schematic drawings perform scheme checks and propose modifications in RLMU. • Familiarity with SAT procedure preparation and execution. • Strong analytical and reporting skills for audit-ready documentation.