Machinist II Cylindrical Grind 2nd Shift Monroe NC

Position Summary

Semi and finish grind all ODs on rotors shafts ring gears etc. Some toolroom grinding such as arbors and bushings.

With own judgement and minimal directions from others produce a quality ground rotor in a safe and efficient manner. Grind all diameters on all rotors shafts etc. Inspect sizes lengths finishes radii etc. Properly fill-out all paperwork monitor coolant and keep good housekeeping.

Principal Activities

Operate one two or more machines including: NCCG CYC lapper etc. Use precision measuring equipment such as micrometer dial caliper profilometer etc. to inspect rotor shafts ring gears and various other parts. Operate electric or air-power crane/forklift.

CANDIDATE REQUIREMENTS

Lift pull and push. Continuously walk or move from one machine to as many as three. Physically load and unload parts. Deburr utilizing a file or other hand tool such as die grinder. Clean parts and centers of chips and wipe dry. Physically lift and check all dimensions machine to conform with finish drawing. Make adjustment on machine as needed to produce quality parts within specifications and standards given/per piece. Utilize multi-function electric or air-crane (where available) to lift/move/load/unload parts to perform workcenter functions. Step up to and down from elevator work platform and on to various parts of machine for wheel changes and cleaning.

RESPONSIBILITIES

Compliance with all rules and regulations normal safety precautions. Work alone recognize and immediately correct machine difficulties or errors; or cause to have corrected; if fault is due to machine tool equipment or material. Maintain a clean safe efficient work area. Maintain all paperwork as needed. Consistently produce work of proper quality and required quantity.

Knowledge Skills & Abilities

Must be able to read and follow detailed instructions. Must be able to fill out forms as needed such as: daily labor report log sheet etc. Use of mathematics reading fairly complicated drawings specifications charts etc

Education & Experience

HS Diploma with 1-3 years machining experience preferred.

Technical Degree in Machining a plus