Knockout Cutoff Operator (3rd OWW)

RESPONSIBILITIES:

• Knock out ceramic from foundry molds with hammer.
• Verification of parts to paper work.
• Alloy type test using X-ray spectrometer.
• Rough and precision cut of castings using abrasive cut-off saw.
• Trim parts using abrasive cut-off saw.
• Ensure proper placement of alloy for revert.
• Ensure proper paper work is with foundry cast molds prior to Knock-Out.
• Perform other duties as assigned.
• Record all work performed in Lot Control.
• Keep the work area in a clean orderly and safe working condition.
• Follow all safety rules.
• Comply with all applicable Standard Operating Procedures.
• Perform all other duties assigned by supervision.

CERTIFICATION OF CUT-OFF:

• 90 days of continuous training required.
• Know all procedures.
• All training documents must be completed and approved before receiving wage increase.

QUALIFICATIONS:

• Pay close attention to detail.
• Must have a good attendance record.
• No written or higher warnings for quality or attendance.
• Must show ability to follow detailed procedures reliably.
• Be able to meet daily production goals.
• Ability to work in a team environment.
• Ability to be self-directed and motivated.
• Capable of handling multiple tasks.
• Demonstrate proficiency of applicable procedure instructions.

REQUIREMENTS:

• Meet or exceed defined Visual Acuity (when required).
• Meet color perception standards needed in performance of job requirements (when required).

Additional training to comply with applicable SOP/Certifications (when required).