Investment Operator 1st Shift OWW 7A-7P

7A-7P

Week 1: Mon Tue Sat Sun

Week 2: Wed Thu Fri (Work 36 hours get paid for 40)

RESPONSIBILITIES:

Must be able to properly operate and maintain all robots used in the dipping of D/S S/C and equiaxed shell
molds.
Interface with Process Engineering and Maintenance staff to identify and/or prevent shell building problems
related to programming and mechanical equipment.
Responsible for the performance of utility personnel in all phases of mold procurement up to and including
setting of lines preparation of mixes and maintaining robotic functions during times when operator need relief.
Compliance to all SOPs and PEIs outlined for Department 620 including documents used for reporting scrap
and mold identification.
Responsible for communication of robot down time and process problems across the shifts.
Licensed to operate a tow motor.
Hand dip all molds liner or wafer plates which do not require robot dipping.
Responsible for maintaining the integrity of all slurries (including levels of both slurry and sands) used in the
shell building process via testing methods and subject SOPs.
Keep work area clean orderly and in safe working condition by performing general housekeeping duties as
instructed by Department Supervisor during shift.
Maintain equipment used in shell building process (slurry tanks pumps and electric lift truck) so as to extend
their useful life.
Perform other duties as assigned by Supervision.
Follow all Plant and Departmental safety rules.
Comply with all applicable Standard Operating Procedures.
Perform all other duties assigned by supervision.
QUALIFICATIONS:
Previous Dip Room or Robotics experience a plus.
Computer Skills
Strong communication skills (oral and written).
Demonstrate proficiency of applicable procedure instructions.
REQUIREMENTS:
Meet or exceed defined Visual Acuity (when required).
Meet color perception standards needed in performance of job requirements (when required).