CNC Setup and Run Operator

To setup and operate Mitsubishi Sheet Laser Trumpf 2510 Laser Trumpf Tube Laser and Trumpf CNC Combo machines. Monday - Thursday 5:00 am - 1:30 pm (32 - 40 hour weeks).

Qualifications :

QUALIFICATIONS:

Education:

• High School Degree Preferred or 5 years relative experience

Experience:

• Must have at least 5 years experience of CNC Lasers and/or Punches preferable Trumpf Machines and controls programs and trouble shooting ability.

ESSENTIAL RESULTS:

• Employee must be able to use measuring equipment (micrometer caliper tape measurer).
• Should be familiar with Punch Control and Windows Operating System.
• Must have blueprint reading experience.
• Must be safety conscious and knowledgeable of:
• All machine safety areas buttons warning list barriers overhead mirrors and emergency switches and handling and disposal of laser dust.
• Should have a basic understanding of mathematics.
• A general knowledge of programming language G code and hands on ability to service and maintain the machine.
• Tool set up
• Clean table and general area
• Change and check all lubricants and daily PMS.
• Understand material characteristics and gages (cold rolled steel aluminum stainless steel).
• Hands on ability to service the machines
• Clean and replace lens nozzles and ceramics located in the head.
• A general knowledge of gases and the process of installation.
• Should have general knowledge of electrical components and schematics.
• Some CNC programming ability.
• Other duties as assigned.
• Aware of the Quality & Environmental Policies & Objectives and understand your role & contribution towards these goals and how activities in your area contribute towards these objectives.
• QMS & EMS Master List - aware where to find documented policies procedures & instructions
• Aware of Significant Environmental Aspects & Impacts (Environmental MGT System)
• Understand Environmental Compliance obligations & implications for non-complying
• Proper MGT & handling of Hazardous & non-hazardous Waste including recycling.
• Participate & support Peerless Emergency Preparedness & response plan.
• Contribute toward EMS & QMS initiatives & improvements to support QMS & EMS Goals & Objectives.

WORKING CONDITION:

• Must be able to work overtime including weekends as needed.
• Must be physically capable of standing/bending/stooping/squeezing 8 hour shift(s)
• Must be able to lift carry and/or move up to 30 pounds on a given day without assistance. Anything above 30 lbs. requires a team lift.
• Must have the ability to push pull material and equipment as needed.
• Must be able to wear required safety equipment including gloves and glasses.

Additional Information :

All your information will be kept confidential according to EEO guidelines.

Remote Work :

No

Employment Type :

Full-time