PQE

Job Description

- Early engage in part-system (PRD ERS) study during NPI co-work with PD/Eng/SDE to standardize & enhance the

material NUDD process establish the early alarm system by analyzing the existing data and predict the risks of future

supply

- Improve and standardize the IQC process and enhance the traceability capability from the E2E supply chain.

- Build up the lessons learned system to drive consistency

Major material issues reporting traceability documentations & visualization which occur/captured at Upper

Stream IQC or FATP.

Study & Research on spec alignment between critical Part/Module and System.

Coordinate a regular platform for knowledge practice and lessons-learnt sharing between SQE & PQE teams

Optimize and coordinate multiple resources (CM Vendors 3rd-parties) for Sourcing Inspection execution.

Vendor OQC & CM IQC optimization and alignment - including test equipment/fixture sourcing test setup

reasonable sampling plan (AQL) vendor OSS arrangement golden/limit samples managements etc.

- Conduct audits at all Contract Manufacturer (CM) sites (including IQC IPQC ORT and OQC etc.) to make sure the

quality procedures and practices are fully aligned. Able to perform quality system & process audits per ISO 9000

requirements.

- Work with clients Product Quality Engineer (PQE) and Contract Manufacturer (CM) Quality Manager/Engineer to set

up regular process audits standardize the audit reporting format and follow up with the CM teams on corrective

actions (CAs) process improvements.

- Perform regular First Article Inspection (and PFOL) for engineering changes or for new part & product (new part

numbers) introduction (BOM Drawing vs actual parts).

- During NPI phase regularly update the status of IQC bring up qualification and correlation study drive parts level

golden & limit sample readiness also support Google PQE to provide training to CM IQC engineers and inspectors.

- Support clients PQE to set up the inspection skill monitor system at CM site and audit the faulty injection test (FIT)

samples and status periodically;

- Work with clients PQE and CM supplier quality engineer to finalize the parts level measurement method and analyze

the measurement data for sub-tier supplier process improvement;

- Support clients PQE to set up traceability control system for all Mechanical parts and Electronic components at NPI

stage;

- Audit CM quality reports to make sure the data is accurate.

- Work with clients PQE and CM quality team to drive quality issue failure analysis (FA) review 5C/8D report and follow

up with the CM/supplier quality teams on corrective actions (CAs) and preventive actions (PAs) implementation