As a Payload System Characterization Integration and RF-Test Engineer you will engage with an experienced cross-disciplinary team to integrate and test the Kuiper-Modem. You will work closely with colleagues throughout Project Kuipers to integrate ASIC HW RF and SW in one single product solution. You will be part of the lifecycle of the development and deployment of the final integrated product.
As a member of Kuiper Payload System Characterization team you will be responsible for integrating the various subsystems RF modem SW-stack etc. to build the product. During this process you will be conducting tests validating each sub-system functionalities and optimizing the end-to-end system
Project Kuiper is Amazons low Earth orbit satellite broadband network. Its mission is to deliver fast reliable internet to customers and communities around the world and weve designed the system with the capacity flexibility and performance to serve a wide range of customers from individual households to schools hospitals businesses government agencies and other organizations operating in locations without reliable connectivity.
Export Control Requirement: Due to applicable export control laws and regulations candidates must be a U.S. citizen or national U.S. permanent resident (i.e. current Green Card holder) or lawfully admitted into the U.S. as a refugee or granted asylum.
Key job responsibilities Integrating various communication Modem functionalities into a single system; from RF (air-interface) to the top layer of the communication stack Specifying and defining test plans to cover the system functionalities with its diverse use cases Building various test beds to enable system testing; e.g. setups of antenna modem measurement equipment etc. Configuring test equipment for automated operation: satellite link emulator spectrum analyzer signal generator etc. Interpreting test results troubleshooting issues performing root-cause analysis for any test failures Specifying with other teams the various KPIs and metrics required to span the whole system characterization
- Bachelors degree in Electrical Engineering Computer Engineering or related discipline or 5 years of RF satellite aerospace or related industry experience. - 2 years experience in in RF design and/or verification with launched products - Experience in embedded C and/or C programming
- Experience in wireless technology e.g. 4G/5G Bluetooth - Experience and hands-on in wireless FW/SW development - Experience with communication theory and RF-systems; e.g. OFDM MIMO etc. - Experience working with different chip interfaces/layers e.g. RF PHY etc. - Experience in wireless (satellite and/or terrestrial) system architecture design and/or implementation. - Experience of end-to-end system integration and testing - Experience with on-orbit payload verification or satellite testing - Hands-on experience with RF measurement equipment including power meters spectrum analyzer vector signal generators network analyzers oscilloscopes.
Amazon is an equal opportunity employer and does not discriminate on the basis of protected veteran status disability or other legally protected status.
Disclaimer: Drjobpro.com is only a platform that connects job seekers and employers. Applicants are advised to conduct their own independent research into the credentials of the prospective employer.We always make certain that our clients do not endorse any request for money payments, thus we advise against sharing any personal or bank-related information with any third party. If you suspect fraud or malpractice, please contact us via contact us page.