Electrical Engineer Support and Technical Project Management

Hope you are doing well.

Please go through the job description. If you are fine please share your updated resume.

Role: EE Support and Technical Project Management

Location: Minden NV

Type: Fulltime

Job Description:

Item

Services Task EE Support and Technical Project Management

B1

Ability to produce multiple solutions and selection of the lowest cost alternative as per design requirements. Optimize analog and digital circuit design by identifying components reviewing endoflife component lifecycles and conducting technical evaluations and testing. Use expertise in power supplies microprocessors microcontrollers memories ethernet controllers peripheral interfaces and displays of industrial products.

B2

Review/compare component specifications between like components from the same and different manufacturers including specifications of all electrical/electromechanical components (purpose of each pin timing speed voltage and current limits) and effects on circuits.

B3

Review electrical circuit design: evaluate circuits and determine which components can be removed to simplify design. Redesign schematics and layouts using printed circuit board design tool Altium designer.

B4

Trained to utilize schematics design tools including Altium Allegro Design Entry ORCAD and PCAD and simulations using LT SPICE to assist in cost reduction activities. Use Six Sigma tools such as Failure Modes Effects and Diagnostic Analysis (FMEDA) to maintain reliability while designing less expensive products.

B5

Overseeing manufacturing processes prototype circuit board design and development activities and electrical bill of material (BoM) preparation for printed circuit boards and interact with component vendors to get information on designs board bring up functional and system testing.

B6

Gain understanding and familiarization of Bently Nevada products and process requirements to enable the engineer to conduct feasibility analysis on PWA changes and provide design changes and support through release of the product changes.

B7

Follows well defined alternate component qualification process and performs qualification testing following Bently Nevada test methodology such as manufacturing tests temperature humidity GTEM HALT and calibration and vibration testing for specific prox. probes seismic sensors and enclosures.

B8

Conduct cost comparisons and feasibility studies on mechanical components such as sheet metal castings machined components standoffs and electromechanical components to help identify potential MCO projects.

B9

Identify and validate critical measurements and tolerance checks of the new components using Bently Nevada lab equipment (CMM optical comparators & profile projectors and gauges). Document design modifications for MCO projects.

B10

Follow proper test methodology utilizing available test equipment such as high vibration tests (seismic lab) temperature and HALT tests and humidity susceptibility and corrosion resistance tests.

B11

Component database Enterprise Resource Planning (ERP) cleanup engineering document creation and release and parts standardization process involved component optimization (reducing/eliminating electrical components) application requirements inputs/outputs and communication protocols.

Thanks and Regards

Puneet Kumar

Smart Bot Systems LLC