Sr Embedded SW & Control Engineer & Electrical Wire Harness Design Engineer & project Manager
Share
Job Location:
Irvine, CA - USA
Monthly Salary:
Not Disclosed
Posted on:
2 hours ago
Vacancies:
1 Vacancy
Job Summary
- Title: Sr Embedded SW & Control Engineer
- No. of Positions: 5
- Location: Irvine CA
- Experience: 4 8 Years
- Attached is the JD for Sr Embedded SW & Control Engineer. Please note that this is an Expert level Embedded SW development role.
Programming & Tools C C MATLAB Simulink
Hardware / Microcontrollers TI C2000 NXP MCU BSP
Communication Protocols CAN Bus ARINC 825 SPI Ethernet ICD
Control Systems State Machines Actuator Control Motor Control BMS Power Sequencing Supervisory Control Fault Management
Testing & Validation MIL SIL HIL Hardware Bring-Up Test Automation
Safety Standards DO-178C ARP4754 ARP4761 ISO 26262
Key Concepts Real-Time Systems Embedded Software Safety-Critical Firmware Middleware Requirements Traceability System Integration Diagnostics
Electrical Wire Harness Design Engineer
- No. of Positions: 1
- Location: Tarrytown NY USA
- Experience: 4 8 Years
- Job Summary
Design build and maintain subsystem characterization testers:
- Power distribution and protection
- Signal conditioning and measurement
- Control interlocks and safety circuits
- Develop custom test hardware (fixtures wiring harnesses test jigs)
- Integrate testers with:
- Mechanical fixtures
- Sensors actuators power electronics embedded systems
- Lab and production environments
Electrical Characterization & Debugging
Hands-On Lab Execution
Required Qualifications
- Bachelors degree in Electrical/Mechanical Engineering or related field
- 4 8 years of hands-on experience in:
- Test system development
- Subsystem-level electrical integration & characterization
- Experience in:
- Analog & digital circuit design/debugging
- Power electronics (low-voltage/high-current systems)
- Strong troubleshooting skills using lab tools
- Experience across full lifecycle: concept build bring-up support
Project Manager
- No. of Positions: 2
- 1 Andover Massachusetts
- 1 Oklahoma City Oklahoma
- Location: Andover MA & Oklahoma City OK
- Experience: 10 Years
Key Requirements
- Education: Bachelors/Masters in Biomedical Mechanical or related field
- Experience: 10 years (5 years in medical device project leadership)
- Certifications: PMP / PRINCE2 / Agile PM
- Technical Skills: MS Office project management tools CAD documentation
- Domain Knowledge: Medical device design controls (21 CFR 820.30)
- Soft Skills: Strong communication problem-solving adaptability
