Electrical Engineer 3
Share
Job Location:
Oxnard, CA - USA
Monthly Salary:
Not Disclosed
Posted on:
5 hours ago
Vacancies:
1 Vacancy
Job Summary
Position: Electrical Engineer 3
Location: Oxnard CA
Type: Full-time On-site
Summary:
The Electrical Engineer 3 designs develops maintains tests and evaluates electronics for the CNC computer control system under the supervision of a senior engineer or department manager.
Essential Duties and Responsibilities include the following:
- Proposes problem solutions through analysis problem definition requirement generation and implementation of proposed solutions.
- Creates documentation and supporting diagrams supporting solutions.
- Prepares schematic designs and simulations which conform to system specifications and electrical best practices.
- Improves workflow by conducting analysis and recommending changes in policies and procedures to management.
- Investigates failures of existing designs and by collecting and analyzing data provides suggestions for failure mitigation and redesign.
- Design electronics hardware.
Qualifications:
- To perform this job successfully the candidate must be able to perform each essential duty adequately.
- The requirements listed below are representative of the knowledge skill and/or ability required.
- Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
Minimum Qualifications:
- 5 years of board-level design experience.
- Knowledgeable of either Altium or Pads to create schematics.
- Must be an active electronics hardware designer.
- Understands firmware and how it affects a hardware design.
- Experience with board-level simulations using a SPICE-based tool.
- Exposure to board layout.
- Exposure to the integration of hardware and firmware into a system.
- Experience defining electronic part specifications.
- Experience with analog mixed signal and general electronics. Exposure to power electronics is a plus.
- Experience with general test equipment like oscilloscopes multimeters and current probes.
- Communicates technical ideas clearly
- Experience using Microsoft Office applications when appropriate.
- Reads and writes technical requirement documentation.
- Experience working with source-control systems.
- Collaborates with and reviews the work with peers.
- Analyzes competing designs and selects the best option.
- 0-5% Travel Required
Education:
- Bachelors Degree BA/BS/BFA/BSA from a four-year college or university is required plus additional related experience training and/or equivalent combination of education and experience.
